Task: Trigger the Atari 8-Bit Computer Screen Saver
Needed: An Atari 8-Bit Computer or Emulator Running BASIC
Time: 5 Minutes or Less
Introduction
Screen burn in was a concern with Cathode Ray Tube (CRT) monitors. This was caused by the phosphor in certain areas of the screen losing their luminescence over time due to repeated excitation. In other words, leaving your monitor on for too long with the same pattern was not good and created ghost images on the screen. Some early home computers had screensavers or attract modes that varied the colors and pattern on the screen to prevent prolonged exposure leading to burn in of the phosphor.
One of the most famous screensavers was the Flying Toasters program on the Macs. The Atari 400 and 800 line of computers had a simple attract mode that would cycle the screen through different colors to help combat burn in. This is a simple program that is part of the operating system included on a motherboard ROM that would start up after a few minutes of non-activity. This can be triggered with a simple BASIC command which is the focus of this simple project.
Instructions
Boot an Atari 8-bit computer or emulator in BASIC and type POKE 77,128 and hit enter. This will trigger the Atari screensaver.

Comments
I tend to forget about the attract mode because I usually don’t let my Atari sit for long periods of time.