Purchase a 3D Printed Case for your SIO2PC (10-15 mins)

Task: Purchase a 3D Printed Case for your SIO2PC

Needed: Web browser

Time: 10-15 minutes

Introduction

I have previously posted about the SIO2PC which is a very handy device for connecting your Atari or floppy drive to your PC for writing and reading files. This is one my most used gadgets, and I find it particularly useful for creating floppy disks using the ProSystem software. I have never liked using it as a bare circuit board and finally purchased a 3D printed case for it.

Instructions

I purchased my 3D printed case from The Robot Factory for $10. You can choose between serial and USB connections and one or two SIO ports. Mine is USB with two SIO ports.

You will need to loosen two small hex screws to get the case apart. Make sure you have a screw driver with a hex head or a small Allen wrench or key.

SIO2PC Case
SIO2PC Case

Comments

I was very happy to receive this and install it. It is very well made and fits the SIO2PC perfectly. Highly recommended!